SW12DE

YOUR WATER HEATER: SUBURBAN SW12DE

Everything for the Suburban SW12DE

12 gallon, LP gas + 120V electric, direct spark ignition (DSI), porcelain-lined steel tank (uses an anode rod), 16-7/32" square cutout. 28 replacement parts listed below.

✓ FIT CHECK

Not sure which part fits? Send us your model and serial number from the data plate and we’ll confirm it before you order.

What’s wrong with your SW12DE?

Suburban 520814 Water Heater Ignition Control Board (fits the SW series) Won’t light / lockout after 3 triesControl Board 520814 →Runs spark and gas. Rule out 12V, gas and the electrode first. Suburban 525005 Water Heater Igniter Electrode (fits all SW series) Clicking or sparking, no flameIgniter Electrode 525005 →Cheap and the most common ignition fix. Check the gap and look for cracks. Suburban 161306 Water Heater Gas Valve (fits newer SW models) Sparks but no gas flowGas Valve 161306 →Changed at a serial break. Check your serial before ordering. Suburban 525007 Water Heater High Temp 12VDC Thermostat (fits the SW series) Water too hot, or not hot enoughThermostat 525007 →Holds water temperature. Most also include the ECO high-limit. Suburban 520900 RV Water Heater AC Heating Element (fits most SW models) Works on propane, not electricAC Heating Element 520900 →The 120V element that heats water on shore power. Suburban 233514 Water Heater Magnesium Anode Rod (fits the SW series) Rusty or rotten-egg smelling waterAnode Rod 233514 →Protects a steel tank from rust. Check it every season. Suburban 525045 Pressure & Temperature Relief Valve – 3/4" NPT Relief valve dripping or stuckPressure Relief Valve 525045 →A safety valve. Some dripping after heating is normal. Suburban 011030 Water Heater Burner Assembly (fits newer SW models) Yellow, sooty or weak flameGas Burner 11030 →Spiders and rust block the burner tube.

Key part numbers for the Suburban SW12DE:

Find your model and serial number on the silver data plate on the right side of the control housing, behind the outside access door.

Common questions

What control board does the SW12DE use?

The Suburban SW12DE uses 520814. Before replacing it, confirm 12V at the board, good gas pressure and a clean, correctly gapped electrode.

Does the SW12DE need an anode rod?

Yes. It has a porcelain-lined steel tank, so the anode rod protects it from rust. Inspect it every time you drain the tank and replace it when it is about 75% gone (233514).

Why does my SW12DE work on propane but not electric?

The usual causes are a burned-out heating element, a failed electric-side thermostat or ECO, a bad switch, or a tripped breaker. Test the element for continuity with the power off. Step-by-step guide.

Where is the model and serial number on the SW12DE?

It is on the silver data plate on the right side of the control housing, behind the outside access door. Several parts changed at serial number breaks, so have both numbers ready when you order.

Time for a new water heater? If the tank is leaking or repairs cost more than the heater is worth, our replacement guide covers sizes and cutouts, or shop 10 gallon RV water heaters.
28 Products