-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
Suburban Mfg
Suburban 525001 Electric Element Switch with Gasket – SW-Series Water Heaters
$19.79$18.00 -
Suburban Mfg
Suburban 090681 Electric Element Cover with Gasket – SW Series Water Heaters
$19.79$18.00 -
-
-
-
-
Suburban Mfg
Suburban 525002 Water Heater High Temp 120V Thermostat (fits the SW series)
$49.99$35.88 -
Suburban Mfg
Suburban 6259 RV Water Heater Access Door (fits the 10, 12 & 16 Gallon Models) | all colors
$119.99$95.55 -
-
-
Suburban Mfg
Suburban 525007 Water Heater High Temp 12VDC Thermostat (fits the SW series)
$39.90$29.35 -
-
-
-
-
Suburban Mfg
Suburban 520814 Water Heater Ignition Control Board (fits the SW series)
$189.99$139.70
SW10DEL

Everything for the Suburban SW10DEL
10 gallon, LP gas + 120V electric, direct spark ignition (DSI), 12V relay for the electric side, porcelain-lined steel tank (uses an anode rod), 16-7/32" square cutout. 30 replacement parts listed below.
✓ FIT CHECK
Not sure which part fits? Send us your model and serial number from the data plate and we’ll confirm it before you order.
What’s wrong with your SW10DEL?
Won’t light / lockout after 3 triesControl Board 520814 →Runs spark and gas. Rule out 12V, gas and the electrode first.
Clicking or sparking, no flameIgniter Electrode 525005 →Cheap and the most common ignition fix. Check the gap and look for cracks.
Sparks but no gas flowGas Valve 161306 →Changed at a serial break. Check your serial before ordering.
Water too hot, or not hot enoughThermostat 525007 →Holds water temperature. Most also include the ECO high-limit.
Works on propane, not electricAC Heating Element 520900 →The 120V element that heats water on shore power.
No power to gas or electric sideSwitch 232882 →Power and element switches wear out and corrode.
Rusty or rotten-egg smelling waterAnode Rod 233514 →Protects a steel tank from rust. Check it every season.
Relief valve dripping or stuckPressure Relief Valve 525045 →A safety valve. Some dripping after heating is normal.Key part numbers for the Suburban SW10DEL:
Find your model and serial number on the silver data plate on the right side of the control housing, behind the outside access door.
Common questions
What control board does the SW10DEL use?
The Suburban SW10DEL uses 520814. Before replacing it, confirm 12V at the board, good gas pressure and a clean, correctly gapped electrode.
Does the SW10DEL need an anode rod?
Yes. It has a porcelain-lined steel tank, so the anode rod protects it from rust. Inspect it every time you drain the tank and replace it when it is about 75% gone (233514).
Why does my SW10DEL work on propane but not electric?
The usual causes are a burned-out heating element, a failed electric-side thermostat or ECO, a bad switch, or a tripped breaker. Test the element for continuity with the power off. Step-by-step guide.
Where is the model and serial number on the SW10DEL?
It is on the silver data plate on the right side of the control housing, behind the outside access door. Several parts changed at serial number breaks, so have both numbers ready when you order.