SAW6DE

YOUR WATER HEATER: SUBURBAN SAW6DE

Everything for the Suburban SAW6DE

6 gallon, LP gas + 120V electric, direct spark ignition (DSI), porcelain-lined steel tank (uses an anode rod), Advantage direct-fit size, made to replace 6-gallon Atwood/Dometic units. 14 replacement parts listed below.

✓ FIT CHECK

Not sure which part fits? Send us your model and serial number from the data plate and we’ll confirm it before you order.

What’s wrong with your SAW6DE?

Suburban 521166 Water Heater Control Board (fits the SAW6D, SAW6DE & SAW6DEL) Won’t light / lockout after 3 triesControl Board 521166 →Runs the spark and gas valve. Rule out 12V, gas and the electrode first. Suburban 520900 RV Water Heater AC Heating Element (fits most SW models) Works on propane, not electricAC Heating Element 520900 →The 120V element that heats water on shore power. Suburban 234229 Water Heater Remote On/Off Switch, Black (LP Gas Only) (fits SW6D/ SW6DE/ SAW6D & more) No power to gas or electric sideSwitch 234229 →Power and element switches wear out and corrode. Suburban 233514 Water Heater Magnesium Anode Rod (fits the SW series) Rusty or rotten-egg smelling waterAnode Rod 233514 →Protects a steel tank from rust. Check it every season. Suburban 232456 Water Heater Electrode Wire (fits SW4D/ SW4DE/ SW4DEL & more) Weak or missing sparkElectrode Wire 232456 →Carries high voltage from the board to the electrode. Suburban 521195 Water Heater High Altitude Derating Kit, SAW6 (Canada) (fits SAW6D/ SAW6DE) Weak flame, slow recoveryBurner Orifice 521195 →Meters the gas to the burner. Blocked orifices cut heat output. Suburban 180260 High Altitude Water Heater Burner Orifice Poor burn at high elevationHigh Altitude Orifice 180260 →Smaller orifice for full-time use at high elevation. Suburban 525025 Water Heater Gas Inlet Elbow Service Kit, 90 Degree (fits SW6DE/ SAW6DE/ SAW6DEL) Gas leak at the inletGas Fitting 525025 →Elbows and fittings for the gas supply line.

Key part numbers for the Suburban SAW6DE:

Find your model and serial number on the silver data plate on the right side of the control housing, behind the outside access door.

Common questions

What control board does the SAW6DE use?

The Suburban SAW6DE uses 521166. Before replacing it, confirm 12V at the board, good gas pressure and a clean, correctly gapped electrode.

Does the SAW6DE need an anode rod?

Yes. It has a porcelain-lined steel tank, so the anode rod protects it from rust. Inspect it every time you drain the tank and replace it when it is about 75% gone (233514).

Why does my SAW6DE work on propane but not electric?

The usual causes are a burned-out heating element, a failed electric-side thermostat or ECO, a bad switch, or a tripped breaker. Test the element for continuity with the power off. Step-by-step guide.

Where is the model and serial number on the SAW6DE?

It is on the silver data plate on the right side of the control housing, behind the outside access door. Several parts changed at serial number breaks, so have both numbers ready when you order.

Time for a new water heater? If the tank is leaking or repairs cost more than the heater is worth, our replacement guide covers sizes and cutouts, or shop 6 gallon RV water heaters.
14 Products