-
-
-
-
-
-
-
Suburban Mfg
Suburban 525001 Electric Element Switch with Gasket – SW-Series Water Heaters
$19.79$18.00 -
Suburban Mfg
Suburban 090681 Electric Element Cover with Gasket – SW Series Water Heaters
$19.79$18.00 -
-
-
Suburban Mfg
Suburban 521166 Water Heater Control Board (fits the SAW6D, SAW6DE & SAW6DEL)
$95.99$77.50 -
SAW6D
Everything for the Suburban SAW6D
6 gallon, LP gas only, direct spark ignition (DSI), porcelain-lined steel tank (uses an anode rod), Advantage direct-fit size, made to replace 6-gallon Atwood/Dometic units. 14 replacement parts listed below.
✓ FIT CHECK
Not sure which part fits? Send us your model and serial number from the data plate and we’ll confirm it before you order.
What’s wrong with your SAW6D?
Won’t light / lockout after 3 triesControl Board 521166 →Runs the spark and gas valve. Rule out 12V, gas and the electrode first.
Works on propane, not electricAC Heating Element 520900 →The 120V element that heats water on shore power.
No power to gas or electric sideSwitch 234229 →Power and element switches wear out and corrode.
Rusty or rotten-egg smelling waterAnode Rod 233514 →Protects a steel tank from rust. Check it every season.
Relief valve dripping or stuckPressure Relief Valve 525045 →A safety valve. Some dripping after heating is normal.
Weak or missing sparkElectrode Wire 232456 →Carries high voltage from the board to the electrode.
Weak flame, slow recoveryBurner Orifice 521195 →Meters the gas to the burner. Blocked orifices cut heat output.
Poor burn at high elevationHigh Altitude Orifice 180260 →Smaller orifice for full-time use at high elevation.Key part numbers for the Suburban SAW6D:
Find your model and serial number on the silver data plate on the right side of the control housing, behind the outside access door.
Common questions
What control board does the SAW6D use?
The Suburban SAW6D uses 521166. Before replacing it, confirm 12V at the board, good gas pressure and a clean, correctly gapped electrode.
Does the SAW6D need an anode rod?
Yes. It has a porcelain-lined steel tank, so the anode rod protects it from rust. Inspect it every time you drain the tank and replace it when it is about 75% gone (233514).
Where is the model and serial number on the SAW6D?
It is on the silver data plate on the right side of the control housing, behind the outside access door. Several parts changed at serial number breaks, so have both numbers ready when you order.