Atwood GC10
Everything for the Atwood GC10
10 gallon, LP gas + 120V electric, aluminum tank (no anode rod needed). 3 replacement parts listed below.
✓ FIT CHECK
Not sure which part fits? Send us your model and serial number from the data plate and we’ll confirm it before you order.
What’s wrong with your GC10?
Yellow, sooty or weak flameGas Burner 93221 →Spiders and rust block the burner tube.
Intermittent power or ignitionWiring Harness 92058 →Connects the board, switch and valves.
Loose door or broken latchDoor Part 91858 →Latches, hinges and frames for the outside access door.Key part numbers for the Atwood GC10:
| Part | Part number(s) for the GC10 |
|---|---|
| Gas Burner | 93221 |
| Wiring Harness | 92058 |
| Door Part | 91858 |
Find your model and serial number on the data plate, visible with the outside access door open.
Common questions
Does the GC10 need an anode rod?
No. It has an aluminum tank, and the tank itself does the job of an anode. Drain and flush it at least once a year and before freezing weather. Don’t install a metal plug or an aftermarket element in the drain opening.
Why does my GC10 work on propane but not electric?
The usual causes are a burned-out heating element, a failed electric-side thermostat or ECO, a bad switch, or a tripped breaker. Test the element for continuity with the power off. Step-by-step guide.
Where is the model and serial number on the GC10?
It is on the data plate, visible with the outside access door open. Several parts changed at serial number breaks, so have both numbers ready when you order.